Pyranha Outfitting – Thigh Braces

  Lots of people lately have been purchasing club spec boats and asking about upgrading the boat with thigh braces, this is a really simple job to do and will take about 10 minutes to complete,

By adding thigh braces will give you much better control of the boat especially in moving water whilst edging the boat, it also allows you to upgrade to a ratchet backrest with the thigh braces pre drilled to take a ratchet.

Here's a quick step by step guide to fitting Connect thigh braces into a club spec Z-One

Collect together the tools needed

1 x Drill with 6mm bit

1 x Marker pen

1 x Philips Screwdriver

1 x Thighbrace kit from Pyranha containing

2 x Connect Thigh braces 4 x bolts 4 x plates 4 x washers and 2 x O-Rings

The boat is premarked during moulding for the thigh brace positions, Take the pen and clearly mark the four imprints

Carefully drill the four holes with the 6mm drill bit.

2 are on the top of the cockpit rim the other 2 come in from the sides

Place the bolts through the drilled holes, Long bolts come in from the side and shorter bolt from the top use the washers on the outside with the rubber O-ring on the longer bolt between the washer and hull

Lift the thigh brace into place, Lining up the bolts.

put the flat plate into the longer bolt and tighten gently

Now slide the thigh brace to check movement and push the bolt through the middle hole in the top (number 3 of 5 holes)

Offer the plate with the extended thread to the bolt, flat side first and carefully tighten

Now tighten the outer bolt untill hand tight.

To adjust remove the top bolt and loosen the side bolt carefully slide the thigh brace to the correct position line up the hole and retighten.

Add a sticker to the boat and you’re done!!

A simple addition to create a secure fit for any paddler,